Single Animation

3.4.8.2.2.1. Single Animation
1

Speed multiplier

1. Speed multiplier
Use this slider for multiplying the speed of the animation by a given value.
2

Root motion

2. Root motion
Check this is you want to use Root Motion for the animation.
3

Source animtion

3. Source animtion
Insert the animation file (an2) you want to associate to the selected Single Animation type.


Do not confuse the animation type (Single,Blend1D, Blend2D) with the source animation file. The first is an element of the list in the modelscript, the latter is the source file in which is contained the animation

4

Split data

4. Split data
This is a list of 4 values, related to the source animation, separated by commas.
These values are inserted automatically when the source animation is loaded, but you can modify them by writing directly into the inputbox.
 
These values are:
Start frame: This is the index of the frame the animation must start. By default the start frame is 0.
End frame: This is the index of the frame at which the animation must end. By default the end frame index is the index of the last frame of the source animation.
Invert: can be 1 or -1 basing on if you want to invert the naimtion playback.
Rate: This values controls the rating at which the animation must be played